Lesson 10/10100%
MODULE 10 -- FINAL

Selection Wizard, Calculators & Final Design Project

Bring together everything from Modules 01-09: get a guided component recommendation, run the numbers with four practical calculators, then complete a capstone design review to finish the course.

Learning Objectives

🧭
Use a guided wizard to get a starting-point protection topology
ðŸ§Ū
Run practical surge protection calculations
🏁
Complete a capstone design review checklist

1. MOV Energy Calculator

Energy: -- J

2. TVS Clamp Voltage Estimator

Clamp voltage: -- V

3. GDT Sparkover Voltage Estimator

Estimated impulse sparkover: -- V

4. Peak Surge Current Estimator

Peak current: -- A
These calculators use simplified, illustrative engineering models for educational purposes. Always validate final component selection against the manufacturer's datasheet and formal compliance testing.

Final Design Project: Pick a real or hypothetical product you work with. For every external port it has, walk through the checklist below as if you were preparing it for IEC 61000-4-5 qualification.

Checklist progress: 0 / 12

FINAL KNOWLEDGE CHECK

Module 10 Quiz

Score: 0 / 12

Select the best answer for each question. Instant feedback is provided after each response.

Question 1 of 12
🎓

Course Complete

You've covered surge sources and propagation, the IEC 61000-4-5 test method and levels, test setup and coupling, procedure and pass/fail criteria, every major protection component, a full design flow with interface-wise topologies, ten real-world case studies, and practical selection and calculation tools. Revisit any module at any time from the sidebar.